RADIUS Authentication and Accounting
Configuring RADIUS Accounting
â– Start-Stop:
• Send a start record accounting notice at the beginning of the account-
ing session and a stop record notice at the end of the session. Both
notices include the latest data the switch has collected for the
requested accounting type (Network, Exec, or System).
• Do not wait for an acknowledgement.
The system option (page 5-21) ignores start-stop because the switch sends
the accumulated data only when there is a reboot, reload, or accounting
on/off event.
â– Stop-Only:
• Send a stop record accounting notice at the end of the accounting
session. The notice includes the latest data the switch has collected
for the requested accounting type (Network, Exec, or System).
• Do not wait for an acknowledgment.
The system option (page 5-21) always delivers stop-only operation because
the switch sends the accumulated data only when there is a reboot, reload,
or accounting on/off event.
Syntax: [no] aaa accounting < exec | network | system > < start-stop | stop-only >
radius
Configures RADIUS accounting type and how data will be
sent to the RADIUS server.
For example, to configure RADIUS accounting on the switch with start-stop
for exec functions and stop-only for system functions:
Configures exec and system
accounting and controls.
Summarizes the switch’s
accounting configuration.
Exec and System accounting are
active. (Assumes the switch is
configured to access a reachable
Figure 5-8. Example of Configuring Accounting Types
5-22
To Next Page
Loading...
Need help?
General