HP ProCurve 5300xl Series Access Security Guide

Configuring Port-Based Access Control (802.1x)
Displaying 802.1x Configuration, Statistics, and Counters
Displaying 802.1x Configuration,
Statistics, and Counters
802.1x Authentication Commands
802.1x Supplicant Commands
802.1x Open VLAN Mode Commands
802.1x-Related Show Commands
show port-access authenticator
show port-access supplicant
Details of 802.1x Mode Status Listings
RADIUS server configuration
page 8-14
page 8-33
page 8-20
below
page 8-42
page 8-39
pages 8-19
Show Commands for Port-Access Authenticator
Syntax: show port-access authenticator [[e] < port-list >]
[config | statistics | session-counters]
•Without [< port-list > [config | statistics | session-
counters]], displays whether port-access
authenticator is active (Yes or No) and the status of
all ports configured for 802.1x authentication. The
Authenticator Backend State in this data refers to the
switch’s interaction with the authentication server.
•With < port-list > only, same as above, but limits port
status to only the specified port. Does not display
data for a specified port that is not enabled as an
authenticator.
•With [< port-list > [config | statistics | session-counters]],
displays the [config | statistics | session-counters] data
for the specified port(s). Does not display data for a
specified port that is not enabled as an authenticator.
•With [config | statistics | session-counters] only,
displays the [config | statistics | session-counters] data
for all ports enabled as authenticators.
For descriptions of [config | statistics | session-counters]
refer to the next section of this table.
8-37

HP ProCurve 5300xl Series Specifications

General

Brand	HP
Model	ProCurve 5300xl Series
Category	Switch
Language	English