HP ProCurve 5300xl Series Access Security Guide

Using Authorized IP Managers
Defining Authorized Management Stations
2. Enter an Authorized Manager IP address here.
5. Press [Enter], then [S] (for Save) to configure the
IP Authorized Manager entry.
3. Use the default mask to allow access by one
management device, or edit the mask to allow
access by a block of management devices. See
“Building IP Masks” on page 10-9.
4. Use the Space bar to select Manager or Operator
access.
Figure 10-2. Example of How To Add an Authorized Manager Entry (Continued)
Editing or Deleting an Authorized Manager Entry. Go to the IP Manag-
ers List screen (figure
10-1), highlight the desired entry, and press
[E] (for Edit)
or
[D] (for Delete).
CLI: Viewing and Configuring Authorized IP Managers
Authorized IP Managers Commands Used in This Section
Command Page
show ip authorized-managers below
ip authorized-managers 10-7
<ip-address> 10-8
mask <mask-bits> 10-8
<operator | manager>
Listing the Switch’s Current Authorized IP Manager(s)
Use the show ip authorized-managers command to list IP stations authorized to
access the switch. For example:
Figure 10-3. Example of the Show IP Authorized-Manager Display
10-6

HP ProCurve 5300xl Series Specifications

General

Brand	HP
Model	ProCurve 5300xl Series
Category	Switch
Language	English