EasyManuals Logo
Home>HP>Switch>ProCurve 5300xl Series

HP ProCurve 5300xl Series Access Security Guide

HP ProCurve 5300xl Series
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #241 background imageLoading...
Page #241 background image
Configuring and Monitoring Port Security
Port Security Command Options and Operation
Removing a Device From the “Authorized” List for a Port. This
command option removes unwanted devices (MAC addresses) from the
Authorized Addresses list. (An Authorized Address list is available for each
port for which Learn Mode is currently set to “Static”. Refer to the command
syntax listing under
“Configuring Port Security” on page 9-8.)
Caution When learn mode is set to static, the Address Limit (address-limit) parameter
controls how many devices are allowed in the Authorized Addresses (mac-
address) for a given port. If you remove a MAC address from the Authorized
Addresses list without also reducing the Address Limit by 1, the port may
subsequently detect and accept as authorized a MAC address that you do not
intend to include in your Authorized Address list. Thus, if you use the CLI to
remove a device that is no longer authorized, it is recommended that you first
reduce the Address Limit (address-limit) integer by 1, as shown below. This
prevents the possibility of the same device or another unauthorized device on
the network from automatically being accepted as “authorized” for that port.
To remove a device (MAC address) from the “Authorized” list and when the
current number of devices equals the Address Limit value, you should first
reduce the Address Limit value by 1, then remove the unwanted device.
Note You can reduce the address limit below the number of currently authorized
addresses on a port. This enables you to subsequently remove a device from
the “Authorizedlist without opening the possibility for an unwanted device
to automatically become authorized.
For example, suppose port A1 is configured as shown below and you want to
remove 0c0090-123456 from the Authorized Address list:
When removing 0c0090-123456, first
reduce the Address Limit by 1 to prevent
the port from automatically adding
another device that it detects on the
network.
Figure 9-7. Example of Two Authorized Addresses on Port A1
9-17

Table of Contents

Other manuals for HP ProCurve 5300xl Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 5300xl Series and is the answer not in the manual?

HP ProCurve 5300xl Series Specifications

General IconGeneral
BrandHP
ModelProCurve 5300xl Series
CategorySwitch
LanguageEnglish

Related product manuals