102
Enhancements
Release L.11.08 Enhancements
Figure 7. An Example of the show config files Command Output
2. To save a configuration file for software version K.12.43, enter this command:
ProCurve(config)# copy config config1 config configK1243.cfg
You can choose any name for the saved configuration file that you prefer.
3. Display the configuration files as shown in Figure 8. You will see your newly created configu-
ration file listed.
Figure 8. A Config File for the Current Software Version is Created
4. Now update your switch to the desired version, for example, K.12.51. Enter the show flash
command to see the results. The switch is now running the software version K.12.51.
Figure 9. Show Flash Command after Upgrading the Switch to a New Version of the Software (K.12.51)
5. If you want to run the prior software version, K.12.43 in this example, enter this command:
ProCurve(config)# boot system flash secondary config configK1243.cfg
ProCurve(config)# show config files
Configuration files:
id | act pri sec | name
---+-------------+------------------------------------------------
1 | * * * | config1
2 | | config2
3 | |
ProCurve(config)# show config files
Configuration files:
id | act pri sec | name
---+-------------+------------------------------------------------
1 | * * * | config1
2 | | config2
3 | | configK1243.cfg
ProCurve(config)# show flash
Image Size(Bytes) Date Version
----- ---------- -------- -------
Primary Image : 6771179 10/15/07 K.12.51
Secondary Image : 7408949 08/24/07 K.12.43
Boot Rom Version: K.12.12
Default Boot : Primary
To Next Page
Loading...
Need help?
General