110
Software Fixes in Release L.10.01 - L.11.09
Release L.10.08
■ Crash (PR_1000339551) — When using the Menu to disable IP routing, the Switch may
crash with a message similar to:
PPC Bus Error exception vector 0x300: Stack-frame=0x0162e030
HW Addr=0x2e2e2e2d.
■ DHCP (PR_1000343149) — Client cannot obtain an IP address when two DHCP servers
are connected on different local networks.
■ Enhancement (PR_1000344652) — Added support for Unidirectional Fiber Break Detec-
tion.
■ Radius EAP (PR_1000334731) — PEAP/TLS EAP types fail to authenticate with Microsoft
IAS Radius Server. The switch event log will report, “can't reach RADIUS server.”
Release L.10.08
Problems Resolved in Release L.10.08 (Not a general release)
■ CLI (PR_1000342461) — When a trunk is configured on an uplink port, the command
"show lldp info remote <port number>" reports incorrect information for the remote manage-
ment address.
■ Enhancement (PR_1000355089) — This enhancement increases the maximum number
of 802.1X users per port to 8.
■ Enhancement (PR_1000355877) — 802.1X Controlled Directions enhancement: with this
change, administrators can use “Wake-on-LAN” with computers that are connected to ports
configured for 802.1X authentication.
■ LLDP (PR_1000310666) — The command output from "show LLDP" does not display
information learned from CDPv2 packets.
■ LLDP (PR_1000301069) — When the LLDP admin status of a port changes from TX to DIS/
RX, the switch does not always send out shutdown frames.
■ LLDP (PR_1000312285) — The old value of the SNMP LLDP-MED trap (lldpXMedRem-
DeviceClass) is supported.
■ LLDP (PR_1000305141) — The LLDP MED Location TLV format is not MED Draft 6
compatible.
To Next Page
Loading...
Need help?
General