EasyManuals Logo

HP ProCurve J8766A User Manual

HP ProCurve J8766A
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #118 background imageLoading...
Page #118 background image
112
Software Fixes in Release L.10.01 - L.11.09
Release L.10.20
Web-UI (PR_1000373711) — Attempting to access the Web UI of a stack member without
being logged on as Manager returns a “404 Page Not Found” error.
NOTE: Versions L.10.12 through L.10.19 were never built. The code branched to L.10.20 with no
intervening releases.
Release L.10.20
Problems Resolved in Release L.10.20 (not a general release)
Please refer to “Release L.10.20 Enhancements” section beginning on page 45 for additional details
on the enhancements listed below.
Enhancement (PR_1000336169) — Added support for STP Per Port BPDU Filtering and
SNMP Traps.
Enhancement (PR_1000346164) — When this feature is enabled on a port, the switch will
disable (drop link) a port that receives a spanning tree BPDU, log a message, and optionally
send an SNMP TRAP.
Enhancement (PR 1000313819) — This enhancement allows SNMP configuration of
RADIUS configuration.
Enhancement (PR 1000292455) — Implemented rate display for ports on CLI. New
command: show interface port-utilization. Not available on Menu or Web Interface.
Enhancement (PR_1000311510) — Ping conformance as defined in RFC 2925
Enhancement (PR_1000331027) — TCP/UDP port closure enhancement.
Enhancement (PR_1000330743) — Denial of Service logging enhancement.
Enhancement (PR_1000338847) — Added support for the Advanced Encryption Stan-
dard (AES) privacy protocol for SNMPv3.
Enhancement (PR_1000339546) — Addition of the clear log CLI command
Enhancement (PR_1000374085) — This enhancement expands the use of the Controlled
Directions parameter to also support mac/web authentication
Enhancement (PR_1000376406) — Loop Protection feature additions, including packet
authentication, loop detected trap, and receiver port configuration.
Enhancement (PR_1000358900) — A RADIUS accounting enhancement was made.
Module Hotswap (PR_1000376980) — When a module is hot-swapped, the switch may
crash with a message similar to:
Software exception at buffers.c:2237 -- in 'mPpmgrCtrl',
task ID = 0x33eea88 -> ASSERT: failed

Table of Contents

Other manuals for HP ProCurve J8766A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve J8766A and is the answer not in the manual?

HP ProCurve J8766A Specifications

General IconGeneral
BrandHP
ModelProCurve J8766A
CategorySoftware
LanguageEnglish

Related product manuals