To Next Page

To Previous Page

111

Software Fixes in Release L.10.01 - L.11.09

Release L.10.09

Problems Resolved in Release L.10.09

■ 802.1X (PR_1000353479) — Changing the supplicant start period (e.g., “aaa port-access

supplicant A1 start-period 15” ) corrupts the supplicant password on a switch that is configured

as a supplicant.

■ Enhancement (PR_1000360934) — Added DHCP Protection enhancement for switch

4200vl.

Release L.10.10

Problems Resolved in Release L.10.10 (not a general release)

■ 802.1x (PR_1000358534) — For the Controlled Directions feature of 802.1X to operate

correctly, spanning tree must be enabled and authenticator ports must be set as edge ports.

This fix removes a limitation that requires these steps be done in a specific order.

■ CLI (PR_1000358129) — The command line interface (CLI) becomes unresponsive after

running RMON traps code.

■ Enhancement (PR_1000351445) — The "show tech transceiver" CLI command output now

contains the HP part number and revision information for all transceivers on the switch.

■ Source Port Filtering (PR_1000352851) — Source Port Filtering on trunks does not work

when both the source and destination are trunk ports, even though the switch accepts the

configuration.

■ Trunking (PR_1000364354) — When a switch with 30 or more trunks is rebooted, the

switch may crash with a message similar to:

NMI event SW:IP=0x00456520 MSR:0x0000b032 LR:0x004564d0

Task='mLpmgrCtrl' Task ID=0x150d940 cr: 0x48000042 sp:0x0150d468

xer:0x00000000

Release L.10.11

Problems Resolved in Release L.10.11 (not a general release)

■ Crash (PR_1000368540) — Switch may crash with a message similar to:

Software exception at parser.c:8012 -- in 'mSess2', task ID =

0x90e10e0 -> ASSERT: failed.

■ Hang (PR_1000346328) — RMON alarms/events configuration files may become corrupt

and prevent initialization, resulting in failure to boot.

■ RADIUS (PR_1000358525) — Attributes that were overridden by RADIUS (CoS, Rate, and

ACL) remain active if an authenticated user fails to send EAP-LOGOFF.

HP ProCurve J8766A User Manual

Other manuals for HP ProCurve J8766A