EasyManuals Logo
Home>HP>Software>ProCurve J8766A

HP ProCurve J8766A User Manual

HP ProCurve J8766A
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #121 background imageLoading...
Page #121 background image
115
Software Fixes in Release L.10.01 - L.11.09
Release L.10.26
Release L.10.26
Problems Resolved in Release L.10.26
IP Connectivity (PR_1000418378) — The switch incorrectly updates its ARP table when
a client, which is configured with a valid IP address for a valid VLAN, is connected to a port
in another VLAN on the switch. This will result in loss of connectivity for the valid client in
the appropriate VLAN.
Crash (PR_1000410959) — If the SNMPv3 user is deleted on the switch without deleting
associated parameters and is then rebooted, the switch may reboot continuously giving a
software exception error similar to:
Software exception at exception.c:373 -- in 'mSnmpEvt', task ID =
0x17d1818 -> Memory system error at 0x17c22e0 - memPartFree
sFlow (PR_1000396889) — If sFlow skip count is set greater than the maximum skip count
or less than the minimum skip count, the switch returns an error. This will prevent PCM from
collecting sampling data.
Crash (PR_1000421322) — When issuing config-related CLI commands (such as show run
or show tech) or when PCM attempts to retrieve the configuration file via TFTP from a switch
having a large configuration file, the switch may crash with a message similar to:
Software exception at exception.c:373 -- in 'tTftpDmn', task ID =
0x11cfaa8 -> Memory system error at 0x1175550 - memPartFree
Web UI (PR_1000421206) — Web UI freezes when logging-in.
Release L.10.27
Problems Resolved in Release L.10.27
802.1x (PR_1000446227) — The 802.1x authentication running over PAP access does not
work if the RADIUS message authenticator attribute is required.
Release L.10.28
Problems Resolved in Release L.10.28
MSTP (PR_1000439775) — The switch generates an MSTP topology change when a port
goes off-line when all ports are set to be an auto-edge-port.
Crash (PR_1000445461) — Setting interface 16 of the J8764A module to non-AUTO will
cause the module to repeatedly crash with a message similar to:
Slot B Bus error: HW Addr=0x70000000 IP=0xe59ff018 Task='mPmSlvCtrl'
Task ID=0x41cbca04fp:0x41cbc7e4 sp:0x41cb

Table of Contents

Other manuals for HP ProCurve J8766A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve J8766A and is the answer not in the manual?

HP ProCurve J8766A Specifications

General IconGeneral
BrandHP
ModelProCurve J8766A
CategorySoftware
LanguageEnglish

Related product manuals