76
Enhancements
Release L.11.08 Enhancements
Figure 9. Example Showing IP Arp-Age Value in the Running Config File
You can set or display the arp-age value using the menu interface (Menu > Switch Configuration
> IP Config).
Figure 10. Example of the Menu Interface Displaying the Arp Age Value
If the ARP cache should become full because entries are not cleared (due to increased timeout limits)
you can use the clear arp command to remove all non-permanent entries in the ARP cache.
ProCurve(config)# show running-config
Running configuration:
; J9091A Configuration Editor; Created on release #K.12.XX
hostname "8200LP"
module 2 type J8702A
module 3 type J8702A
module 4 type J8702A
ip default-gateway 15.255.120.1
ip arp-age 1000
snmp-server community "public" Unrestricted
snmp-server host 16.180.1.240 "public"
vlan 1
name "DEFAULT_VLAN"
untagged B1-B24,C1-C24,D1-D24
ip address 15.255.120.85 255.255.248.0
exit
gvrp
spanning-tree
ProCurve 12-June-2007 14:45:31
===========================- TELNET - MANAGER MODE ======================
Switch Configuration - Internet (IP) Service
IP Routing : Disabled
Default Gateway : 15.255.120.1
Default TTL : 64
Arp Age : 1000
IP Config [Manual] : Manual
IP Address : 15.255.111.11
Subnet Mask : 255.255.248.0
Actions-> Cancel Edit Save Help
To Next Page
Loading...
Need help?
General