88
Enhancements
Release L.11.08 Enhancements
This command shows VLAN memberships associated with a port or a group of ports.
The follow examples illustrate the displayed output depending on whether the detailed option is used.
Syntax show vlan ports < port-list > [detailed]
Displays VLAN information for an individual port or a group of ports, either
cumulatively or on a detailed per-port basis.
port-list: Specify a single port number, a range of ports (for example, a1-a16), or all.
detailed: Displays detailed VLAN membership information on a per-port basis.
Descriptions of items displayed by the command are provided below.
Port name: The user-specified port name, if one has been assigned.
VLAN ID: The VLAN identification number, or VID.
Name: The default or specified name assigned to the VLAN. For a static VLAN,
the default name consists of VLAN-x where “x” matches the VID assigned to that
VLAN. For a dynamic VLAN, the name consists of GVRP_x where “x” matches the
applicable VID.
Status:
Port-Based: Port-Based, static VLAN
Protocol: Protocol-Based, static VLAN
Dynamic: Port-Based, temporary VLAN learned through GVRP.
Voice: Indicates whether a (port-based) VLAN is configured as a voice VLAN.
Jumbo: Indicates whether a VLAN is configured for Jumbo packets. For more on
jumbos, refer to the chapter titled “Port Traffic Controls” in the Management and
Configuration Guide for your switch.
Mode: Indicates whether a VLAN is tagged or untagged.
To Next Page
Loading...
Need help?
General