Front I/O assembly
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Remove the access panel (
Access panel on page 20).
3. Remove the front bezel (
Front bezel on page 21).
4. Rotate the drive cage to its upright position.
5. Cut the plastic tie that secures the longer cable to the power supply.
6. Disconnect the cables from the system board as follows:
●
Yellow connector labeled FRONT USB
●
Blue connector labeled FRONT USB 3.0
●
Blue connector labeled FRONT AUD
48 Chapter 4 Removal and replacement procedures: Small Form Factor
To Next Page
Loading...
