HP ProDesk 400 G2 Small Form Factor User Manual

Drive positions
1 Slim optical drive bay
2 3.5-inch internal hard drive bay
3 3.5-inch drive bay for optional drives (media card reader shown)
4 2.5-inch internal hard drive bay
NOTE: The drive configuration on your computer may be different than the drive
configuration shown above.
To verify the type and size of the storage devices installed in the computer, run Computer Setup.
Removing a 3.5-inch device
CAUTION: All removable media should be taken out of a drive before removing the drive from the
computer.
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Remove the access panel (
Access panel on page 20).
3. Remove the front bezel (
Front bezel on page 21).
4. Rotate the drive cage to its upright position.
34 Chapter 4 Removal and replacement procedures: Small Form Factor

HP ProDesk 400 G2 Small Form Factor Specifications

General

Brand	HP
Model	ProDesk 400 G2 Small Form Factor
Category	Desktop
Language	English