Hardware options installation 72
To install the component:
1. Power down the server (on page 17).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 17).
o Remove the server from the rack (on page 19).
4. Remove the access panel (on page 20).
5. Remove the air baffle.
6. Remove the PCI blank or PCI cage, if installed.
Retain the blank and screws for future use.
To Next Page
Loading...
