Removal and replacement procedures 66
Figure 48 Removing the PCI cage
Installing PCIe riser board
The system supports up PCIe riser board. Use only HP supported expansion board that meets the
following specifications:
To remove the PCIe Riser card:
1. Loosen the two screws securing the riser card to the PCI cage.
2. Push the riser card down and away from the PCI cage.
Figure 49 Removing the PCIe riser card
To install the PCIe Riser card:
1. Align the riser card slot to the standoff on the PCI cage, and then push the card up.
2. Install and tighten the two screws that secure the riser card to the PCI cage.
To Next Page
Loading...
