Removal and replacement procedures 67
Figure 50 Installing the PCIe riser card
To remove the slot cover:
1. Loosen the screw(s) that secure(s) the slot cover(s) to the chassis.
2. Remove the slot cover(s) on the PCI cage.
CAUTION: Do not discard the slot cover. If the expansion board is removed in the future, the slot
cover must be reinstalled to maintain proper cooling.
Figure 51 Removing the slot cover
To install the PCI card:
1. Slide the expansion board into the slot, aligning the board with its matching connector.
Firmly press the board to seat it properly on the slot.
2. Tighten the screw that secures the card to the PCI cage.
To Next Page
Loading...
