About this task
Follow the steps below to replace the DL360G9 CHASSIS FAN.
Note:
Always follow safe electrostatic discharge practices.
Procedure
1. Replace any required non - functioning fans and restart the server if necessary. Fans are
hot-swappable.
2. To remove the component:
a. Extend the server from the rack. If the server is to remain on with application up, ensure
power cord does not disconnect when extending server from rack.
b. Remove the access panel.
Internal Field Replaceable Units
November 2015 Maintaining and Troubleshooting the HP ProLiant DL360 G9 Server 31
Comments on this document? infodev@avaya.com
To Next Page
Loading...
