HPE ProLiant DL360 Generation9 (Gen9)
Advanced ECC uses single device data correction to detect and correct single and
all multibit error that occurs within a single DRAM chip.
Memory online spare mode detects a rank that is degrading and switches
operation to the spare rank.
Full-height,
half-length slot
NOTE: Bus Width indicates the number of physical electrical lanes running to the connector.
Full-height, full-
length slot
Full-height, full-
length slot
NOTE: *If secondary FH kit (867249-B21) is installed, then primary PCIe Slot 2 cannot be used. Only 2
One of the following
depending on model
HPE Dynamic Smart Array B140i Controller
HPE H240ar Smart Host Bus Adapter
NOTE: For E5-2600v3 Entry models, the embedded B140i will operate in UEFI mode only.
• For legacy mode support an additional controller will be needed.
• For CTO orders please also select "HPE Legacy FIO Mode Setting", 758959-B22.
NOTE: The embedded B140i defaults to AHCI off the chipset. HPE Dynamic Smart Array Controller
needs to be enabled on the SATA
HPE Flexible Smart Array P440ar/2GB
HPE Flexible Smart Array P440ar/2GB
Devices
One of the following
depending on model
8 SFF with optional Universal Media bay
Option Kit 764632-B21 VGA, SFF DVD-RW USB Kit
Option Kit
818213-B21 VGA, SFF DVD-ROM USB Kit
Option Kit 726536-B21 - HPE 9.5mm SATA DVD-ROM Jb Gen9 Kit
Option Kit 726537-B21 - HPE 9.5mm SATA DVD-RW Jb Gen9 Kit
NOTE: Optical cable kit Required for optical drives, 766203-B21.
8 SFF with optional Universal Media Bay or NVMe drive support
10 SFF; 8 SFF Model with optional 2 SFF SAS/SATA kit: 764630-B21
NOTE: HPE ProLiant DL360 Servers offer both SFF and LFF versions.
NOTE:
Pre-configured models come populated with some hard drive blanks.