Hardware options installation 45
NOTE: The server ships standard with five hard drive blanks.
Installing a hot-plug SCSI hard drive
1. Remove the existing hard drive blank or hard drive from the drive bay ("Removing a hot-plug SCSI
hard drive" on page 45).
2. Install the hard drive.
3. Determine the status of the hard drive from the hot-plug hard drive LEDs ("Hot-plug SCSI hard drive
LEDs" on page 18).
4. Resume normal server operations.
Removing a hot-plug SCSI hard drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
1. Determine the status of the hard drive from the hot-plug hard drive LEDs ("Hot-plug SCSI hard drive
LEDs" on page 18).
To Next Page
Loading...
