Hardware options installation 48
3.
Install the hard drive.
4. Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations (on page
20).
Removing a hot-plug SAS hard drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
1. Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations (on page
20).
2. Back up all server data on the hard drive.
3. Remove the hard drive.
Installing a diskette drive
NOTE: This procedure shows images of the SCSI model server, but it also applies to the SAS model server.
To Next Page
Loading...
