Hardware options installation 49
1.
Power down the server (on page 27).
2. Extend the server from the rack, if applicable ("Extend the server from the rack" on page 28).
3. Remove the access panel ("Removing the access panel" on page 29).
4. Remove the protective cover on the server bezel from the front of the diskette drive bay.
5. Slide the diskette drive into the diskette drive bay.
6. Tighten the thumbscrew.
7. Secure the diskette drive cable to the diskette drive cable connector on the SCSI backplane or the
SAS backplane.
Hot-plug tape drive option
NOTE: This feature applies only to SCSI models.
1. Remove the existing hard drive blank or hard drive from the upper-left drive bay ("Removing a hot-
plug SCSI hard drive" on page 45).
To Next Page
Loading...
