Removal and replacement procedures 58
14.
Using your fingers, remove the failed processor.
CAUTION: To avoid damage to the system board:
• Do not touch the socket contacts.
• Always install the processor socket cover after removing the processor from the socket.
• Do not tilt or slide the processor when removing the processor from the socket.
CAUTION: To avoid damage to the processor:
• Handle the processor only by the edges.
• Do not touch the bottom of the processor, especially the contact area.
15. Disconnect all cables connected to the system board.
16. Remove the retaining screw at the rear of the chassis.
17. Loosen the system board thumbscrews.
18. Remove the power supply cage assembly ("Power supply cage assembly" on page 48).
19. Remove the failed system board.
To Next Page
Loading...
