HP ProLiant DL585

Server setup
3-20 HP ProLiant DL585 Server User Guide
Attaching the cable management arm
The cable management arm ships with a round-hole bracket and a square-hole
bracket. Use the appropriate bracket instructions for the server rack.
Attaching the cable management arm to a square-hole rack
1. Slide the bracket onto the rack.
2. Insert the bracket hooks into the square holes on the rack, and then push down to
secure.
3. Tighten the thumbscrew to stabilize the cable management arm on the rack.
Figure 3-15: Securing the cable management arm to the
square-hole rack