HP ProLiant DL585

Installing hardware options
HP ProLiant DL585 Server User Guide 4-19
Switching from duplex to simplex mode
The server ships in duplex mode. To switch from duplex to simplex mode:
1. Power down the server. Refer to “Powering down the server” in Chapter 2,
“Server operations.”
2. Extend the server from the rack. Refer to “Extending the server from the rack” in
Chapter 2, “Server operations.”
3. Remove the access panel. Refer to “Removing the access panel” in Chapter 2,
“Server operations.”
4. Locate the simplex/duplex switch.
Figure 4-17: Locating the simplex/duplex switch
5. Move the switch from duplex to simplex.
6. Reinstall the access panel.
7. Restore the server to its operating position in the rack.
8. Power up the server.