Hardware options installation 44
13.
Route the Mini-SAS cables through the clip and connect the connectors to the drive backplane.
o H240 Host Bus Adapter to the 4 LFF drive backplane
o P440 Smart Array Controller to the 4 LFF drive backplane
14. Connect the rest of the drive cables required in this drive configuration. For more information, see
"Storage cabling (on page 80)."
15. Install the access panel (on page 19).
16. Install the server into the rack.
17. Power up the server (on page 15).
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
18. Install the drives.
To Next Page
Loading...
