Hardware options installation 46
6.
Install the optical drive into the bay.
7. Connect the optical drive cable to the optical drive.
8. Route the optical drive cable through the cable clip, connect the cable to the system board SATA
connector, and then connect the power cable to the system board power cable connector:
9. Install the access panel (on page 19).
10. Do one of the following:
o Slide the server into the rack.
o Install the server into the rack.
11. Power up the server (on page 15).
Redundant fan option
To provide sufficient airflow to the system if a fan rotor fails, the server supports redundant fans.
To Next Page
Loading...
