TheIntegratedLights-Outportonthestorageservercanbeconfigured through the Rapid Startup Wizard
or through the iLO 2 ROM-Based Setup Utilit y (RBSU) . SNMP is enabled and the Insight Managem ent
Agents are preinstalled.
The HP iLO 2 m anagement processor provides multiple ways to configure, update, operate, and manage
servers remotely. The HP ProLiant Storage Server comes preconfigured with iLO 2 default factory settings,
including a default user account and password. These settings can be found on the iLO 2 Default
Network Settings tag found on the front of the server. If iLO 2 is connected to a network running DNS
and DHCP, you can use it immediately without changing any settings.
For more information on using HP iLO 2, see the HP Integrated Lights-Out 2 User G uide.
To quickly set up iLO 2 using t he default set tings for iLO 2 Standard and iLO 2 Advanced features,
follow the steps below
1. Ensure that a n etwork c able is connected to the iLO 2 port located on the back of the storage server.
NOTE:
This connection method is easiest when the connection is to a DHCP and DNS supported
network.
2. If not using dynamic DHCP (IP addressing), you will need to input a static IP address by using
the direct attach method and the iLO 2 RBSU.
3. Using the methods described in the HP Integrated Lights–Out 2 User Guide, connect to the iLO 2 port.
NOTE:
To findthedefaultiLO2loginsettings,seetheiLO2DefaultNetworkSettingscard
attached to your server. The default DNS, administrator name, and password needed to
log in will be on this card.
4. If desire
d, you can change the default user name and password on the administrator account to
your pre
defined selections.
5. Set up your user accou nts, if using the local accounts feature.
6. Activate iLO 2 advanced features by entering a license key from the included ProLiant Essentials
Integrated Lights-Out 2 Advanced Pack.
7. AccesstheHPProLiantStorageServerusingtheiLO2RemoteConsolefunctionality.LogintotheHP
ProLiant Storage Server with the default user name administrator and the password hpinvent.
The HP
ProLiant Storage Server Management console starts automatically.
NOTE:
When t
he Remote Console feature is enabled, you can get access to the storage ser ver's
login screen.
The Integrated Lights-Out 2 port comes with factory default settings, which the administrator can change.
Administrators may want to add users, change SNMP trap destinations, or change networking settings.
Refer to the HP Integrated Lights-Out 2 User Guide for information about changing these settings. To
obtain this guide, go to h
ttp://ww w.hp.com/supp ort/manu als, navigate to the ser vers section, and
select Server management. In the ProLiant Essentials Software section, select HP Integrated Lights-Out 2
(iLO 2) Standard Firmware.
24
Installing and configuring the server
To Next Page
Loading...
Need help?
General
