HP RP2 2000 User Manual

7. Slide the new power supply into the left side of the base.
8. Connect the AC power cord to the right side of the power supply inside the base (1), insert the cord into
the routing slot on the bottom edge of the base (2), and then route the cord under the base behind the
foot (3) and out the rear of the base (4).
9. Route the DC cable on the left side of the base up through the hole in the center of the base and connect
the cable to the DC power connector on the rear of the display head.
Power supply 25

HP RP2 2000 Specifications

General

Brand	HP
Model	RP2 2000
Category	Touchscreen
Language	English