1 Install the Operating System
CAUTION: Do not add optional hardware or third-party devices to your computer until the operating
system is successfully installed. Doing so may cause errors and may prevent the operating system from
installing properly. Once the automatic installation has begun, DO NOT TURN OFF THE COMPUTER
UNTIL THE PROCESS IS COMPLETE. Turning off the computer during the installation process might
damage the software that runs the computer or prevent its proper installation.
NOTE: Operate the computer on a sturdy, level surface. The front should be 100% open. Leave a 10-
mm (.39-inch) clearance on the sides and top of the computer and at least a 50-mm (1.97-inch) clearance
in the rear. The rear vents should be 100% open.
The first time the computer is turned on, the operating system is automatically installed. This process
takes about 5 to 10 minutes, depending on the operating system being installed. Carefully read and
follow the instructions that appear on the screen to complete the installation.
NOTE: If the computer was shipped with Microsoft Windows Vista loaded, you will be prompted to
register the computer with Total HP Care before installing the operating system. You will see a brief
movie followed by an online registration form. Fill out the form, click the Begin button, and follow the
instructions on the screen.
If the computer was not shipped with a Microsoft operating system, some portions of this documentation
do not apply. For complete operating system installation and configuring instructions, refer to the
operating system documentation. Additional information is available in online help after you install the
operating system.
Microsoft security updates are available on the Microsoft Web site.
Installing or Upgrading Device Drivers
To install optional hardware devices after the operating system installation is complete, the drivers for
each of the devices must also be installed.
If prompted for the I386 directory, replace the path specification with C:\i386, or use the Browse
button in the dialog box to locate the i386 folder. This action points the operating system to the
appropriate drivers.
Obtain the latest support software, including support software for the operating system from
http://www.hp.com/support. Select the appropriate country and language then, select Download
drivers and software, enter the model number of the computer, and press Enter.
NOTE: If the computer has a writable optical drive, install the appropriate application to be able to
write to the drive.
ENWW Installing or Upgrading Device Drivers 1
To Next Page
Loading...
