Front Drive Bezel
1. Prepare the computer for disassembly (Preparation for Disassembly on page 61).
2. Remove the computer cover (
Computer Cover on page 64).
3. Push the bezel blank outward from the center of the part, so that it is bowed out.
Figure 7-4 Flexing the Bezel Blank
4. With the bezel blank bowed, push its end into the chassis to remove it from the unit.
Figure 7-5 Removing the Bezel Blank
To install a bezel blank, reverse the removal procedure.
ENWW Front Drive Bezel 65
To Next Page
Loading...
