Speaker
1. Prepare the computer for disassembly (Preparation for Disassembly on page 61).
2. Remove the computer cover (
Computer Cover on page 64).
3. Remove the fan shroud (
Fan Shroud on page 103).
4. Raise the drive cage to its upright position. .
5. Disconnect the speaker wire from the system board.
6. Disconnect the speaker wire from the system board then bend the speaker wire retaining clips
down slightly (1) to release the wires. Remove the single screw that secures the speaker to the
chassis (2) and remove the speaker.
Figure 7-55 Removing the Speaker
To install the speaker, reverse the removal procedures.
ENWW Speaker 107
To Next Page
Loading...
