Power Supply
WARNING! Voltage is always present on the system board when the computer is plugged into an
active AC outlet. To avoid possible personal injury and damage to the equipment the power cord should
be disconnected from the computer and/or the AC outlet before opening the computer.
1. Prepare the computer for disassembly (Preparation for Disassembly on page 61).
2. Remove the computer cover (
Computer Cover on page 64).
3. Rotate the drive cage up and disconnect the power cables from all of the drives.
4. Press the release latch (1) and rotate the power supply to its full upright position (2).
5. Disconnect the power cables from the system board and lift the power supply straight up and out
of the chassis (3).
Figure 7-58 Removing the Power Supply
To install the power supply, reverse the removal procedure.
CAUTION: When installing the power supply cables, make sure they are properly positioned so they
are not cut by the drive cage and are not pinched by the rotating power supply.
ENWW Power Supply 111
To Next Page
Loading...
