10. Press the latch release on the front of the power supply (1), and then raise the power supply to the
upright position (2).
Figure 7-11 Releasing and Rotating the Power Supply
11. Open both latches of the memory module socket (1), and insert the memory module into the
socket (2).
NOTE: A memory module can be installed with the tab on the memory socket.
For maximum performance, populate equally as possible.
12. Push the module down into the socket, ensuring that the module is fully inserted and properly
seated. Make sure the latches are in the closed position (3).
Figure 7-12 Installing a DIMM
13. Repeat steps 10 and 11 to install any additional modules.
To reassemble the computer, reverse the removal procedure.
ENWW Memory 73
To Next Page
Loading...
