13. To install a new expansion card in the riser card, align the bracket on the expansion card with the
open slot on the rear of the chassis and press the card straight into the expansion socket.
Figure 7-23 Installing a PCI Expansion Card
NOTE: When installing an expansion card, press firmly on the card so that the whole connector
seats properly in the expansion card slot.
14. Close the slot cover retainer.
Figure 7-24 Closing the Riser Card Slot Cover Retainer
NOTE: The slot cover retainer is secured in place by the computer cover.
15. Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
16. Return the power supply to the down position until it locks.
To reassemble the computer, reverse the removal procedure.
ENWW Expansion Cards 81
To Next Page
Loading...
