Why is the OK LED off on my HP StorageWorks 2324fc controller module?
If the OK LED is off on your HP Network Hardware controller module, it may be because the controller module is not powered on or has failed. Ensure the controller module is fully inserted and latched in place, and verify that the enclosure is powered on.
What to do if a connected host port’s Host Link Status LED is off on HP Network Hardware?
If a connected host port’s Host Link Status LED is off on your HP Network Hardware, the link is down. Check cable connections, reseat the cables, or replace the cables. In SMU, review the event logs for indicators of a specific fault in a host data path component.
What to do if a connected port’s Expansion Port Status LED is off on HP StorageWorks 2324fc Network Hardware?
If a connected port’s Expansion Port Status LED is off on your HP Network Hardware, the link is down. Check cable connections, reseat the cables, or replace the cables. Also, in SMU, review the event logs for indicators of a specific fault in a host data path component.
General| Host Interface | Fibre Channel |
|---|---|
| Number of Drives | 24 |
| Form Factor | 2U |
| RAID Levels Supported | 0, 1, 5, 10, 50 |
| Cooling | Redundant fans |
| Power Supply | Redundant power supplies |
| Ports | 4 |
| Port Type | Fibre Channel |
| Data Transfer Rate | 4 Gbps |
| Compatibility | HP ProLiant, HP Integrity servers |
| Operating Humidity | 20% to 80% non-condensing |
Provides a step-by-step sequence for installing the storage system components.
Instructions for cabling the controller enclosure with drive enclosures.
Procedure to verify that all enclosure connections are established correctly.
Steps to acquire and set management port IP addresses using DHCP or CLI.
Specifies the necessary criteria for host systems connecting to the array.
Guides on establishing connections between the storage enclosure and host servers.
Details how to connect hosts directly to the storage system.
Explains how to connect hosts via Fibre Channel switches.
Instructions for connecting management systems over an Ethernet network.
Provides procedures for starting up and shutting down the storage system.
Explanation of the status indicator lights on the front of the enclosure.
Describes the LEDs associated with individual hard drives.
Explanation of the status indicator lights on the rear of the enclosure.
Describes the status indicators for the system's power supply units.
Steps to ensure the web browser is properly set up for the SMU.
Procedure for accessing the SMU interface from a local computer.
A guide to the wizard for initial system configuration.
A guide to the wizard for creating and mapping virtual disks.
Steps to verify that the system configuration is successful.
Outlines the systematic approach to diagnosing and locating faults within the system.
First step in troubleshooting: collecting relevant data and system status.
Locating the specific area or component where the fault is present.
Using system event logs to analyze faults and identify causes.
Techniques to narrow down the fault to a specific FRU or connection.
Specific troubleshooting steps for when an enclosure fails to initialize.
Detailed troubleshooting flowcharts based on LED indicators.
Addresses issues related to controller failure in specific configurations.
Troubleshooting steps for faults in host connectivity.
Troubleshooting for faults related to expansion port connections.
Guidance on addressing system warnings related to voltage and temperature.
To Next Page