Network configuration using net set wizard
NOTE: See Example network environment (page 34) for a diagram illustrating the network
configuration that we are creating in this example.
The net set wizard guides you through the network configuration on the StoreOnce Backup
system and configures all network settings for all subnets.
Before running the wizard collect and verify the required information, see Before running net set
wizard (page 39).
To make additions or modifications to an existing network configuration, do not use net set
wizard because this will overwrite the current configuration. Instead, use the net modify or
net add CLI commands, as described in Modifying a network configuration (page 48) and the
HP StoreOnce Backup system CLI Reference guide.
NOTE: If you wish to configure encryption on a subnet, you can only do this using the StoreOnce
CLI commands. It is not configurable using the wizard. See To add Data in Flight
Encryption (page 49).
In the following example we shall use the net set wizard to support the following network
configuration:
• Two DNS servers
• One Port Set that uses the eth0 port only and will be used for a DHCP subnet.
• A second Port Set that is used for the Backup Data subnets and uses the bonded pair of 10
Gbit ethernet ports, eth4 and eth5. This Port Set is VLAN-enabled. We shall set up one IPv4
VLAN subnet and one IPv6 VLAN subnet initially using the wizard, and then illustrate how to
modify the configuration to add a third VLAN subnet.
• A third Port Set that is used for StoreOnce Catalyst Copy and Replication subnet across the
WAN and uses the bonded pair of 1 Gbit ethernet ports, eth2 and eth3. We wish to use
Mode 6 bonding on this Port Set, so it cannot be VLAN enabled. This subnet will also be
configured with the default gateway.
NOTE: The wizard runs continuously. You cannot interrupt it and save the configurations already
specified. However, for the purposes of this example, we have split it into sections to add notes.
1. First, we shall specify the DNS servers and create Portset1 on eth0. We shall keep this as
DHCP in line with the Quick Install option. In reality, you are more likely to re-configure this
Port Set with static IP addresses, but we shall illustrate this as a post-installation example. See
Modifying a network configuration (page 48) for more information.
# net set wizard
StoreOnce Network Configuration Wizard
--------------------------------------
This Wizard will guide you through the configuration of
network settings on your StoreOnce Backup System.
If you wish to make additions or modifications to an existing
network configuration without having to reconfigure all settings,
use the 'net modify' or 'net add' commands instead.
See the User Guide guide for physical port layout details.
The wizard consists of the following steps:
Step 1) Set system wide DNS server addresses (optional) and cluster size (if multi-node)
Step 2) Configure network settings for available network adapters
Step 3) Save and apply all network settings
Type 'quit' + ENTER at any time to exit wizard.
Step 1) Set system wide DNS server addresses (optional) and cluster size (if multi-node)
----------------------------------------------------------------------------------------
Enter a list (max 3) of DNS servers separated by commas; this list may be blank.
The IP version used here must match that used on the management interface later on.
For example, for IPv4: 192.168.1.100,192.168.3.100
Network configuration using net set wizard 41
To Next Page
Loading...
