Service Sets Status Notes
------------ ------ -----
Set 1 Running
4. Once the discovery process is complete, run the following command in order to format the
storage LUN with file system segments:
hardware add storage
This command will expand the filesystem to use the storage. The process can take a long time
to complete and the new capacity will not be available until it is finished.
5. Monitor the expansion using the following command:
system show status
This command will return either of the following after an add command has been sent:
Adding X,XXXGB... or Formatted XXGB
The following output is an example; the values shown may not match your appliance specific
values.
# system show status
Status
------
Formatted 15,070.76GB
Service Sets Status Notes
------------ ------ -----
Set 1 Running
Accessing the StoreOnce Backup system over SFTP
There are a number of occasions when you may need to access the HP StoreOnce Backup system
over SFTP:
• To transfer software update packages to the correct location in the StoreOnce folder structure.
• To access files that are generated and stored in the StoreOnce folder structure, such as the
support tickets (in the /tickets folder), software upgrades (in the /repository folder)
and the saved configurations (in the /config folder).
Figure 24 StoreOnce folder structure
Accessing the StoreOnce Backup system over SFTP 63
To Next Page
Loading...
