HP Storevirtual 4000 - Page 32

(equivalent to the required 64 percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of the rack must be a
minimum of 2.75 inches (7 cm).
CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This
arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling that
can lead to thermal damage.
Rack Kit HP StoreVirtual rack models have fixed rails which provide support for racks with round mounting
holes and tool-free support for racks with square mounting holes (including Compaq/HP 7000, 9000,
10000 and i-Series), with an adjustment range of 26" - 36".
Telco Rack Support - Support for all 2 and 4 post Telco racks and threaded hole racks requires an
additional option kit from Rack Solutions. The Rack Solutions brackets can be purchased at:
http://www.racksolutions.com/hp/
NOTE: Cat5e cables are required to connect Interface Adapters to Console Switches. Cat5e cables can be
found at the following URL: http://www.hp.com/go/kvm .
NOTE: It is mandatory to use a shock pallet when shipping racks with equipment installed.
NOTE: Please see the QuickSpecs for Technical Specifications and additional information:
http://h18004.www1.hp.com/products/quickspecs/14223_na/14223_na.html
NOTE: For additional information regarding Rack Cabinets, please see the following URL:
http://www.hp.com/go/rackandpower .
QuickSpecs
HP StoreVirtual 4000 Storage
Configuration Information
DA - 14437 Worldwide — Version 13 — December 9, 2013 Page 32