910166-001 – For use on computer models in aqua blue nish
910164-001 – For use on computer models in jet black nish
912836-001 – For use on computer models in snow white nish
910165-001 – For use on computer models in violet purple nish
L21649-001 – For use on computer models in innity purple nish
4. Remove the three Phillips M2.5×4.3 screws (2) and the two Phillips M2.5×6.3 screws (3) that secure
the bottom cover to the computer.
5. Insert a case utility tool (1) or similar plastic, at-edged tool between the bottom cover
and the computer near the display hinge area.
6. Release the bottom cover (2) by swinging the rear edge up and forward until it releases.
7. Remove the bottom cover (3).
Reverse this procedure to install the bottom cover.
Component replacement procedures 29
To Next Page
Loading...
Need help?
General