HP t610 Series User Manual

4. Slide the access panel about 6.35 mm (1/4 inch) toward the bottom of the unit, and then lift the
access panel up and off the chassis.
Figure 2-2 Removing the side access panel
Removing the left metal side cover
NOTE: Do not remove the metal side cover to install a SODIMM. The SODIMM compartment is in
the right side of the chassis.
You must remove the metal side cover to access internal components such as the battery or to install
a flash memory module, internal hard drive, or PCI-Express card.
1. Push the tab in the front edge of the side cover toward the back to release the sided cover (1).
2. Lift the front edge of the metal side cover (2), then pull the cover to the front and lift it off the
chassis (3).
Figure 2-3 Removing the metal side cover
Replacing the left metal side cover
1. Place the metal side cover on the chassis, rear edge first, making sure to insert the two tabs of
the rear edge into the notches in the chassis (1).
12 Chapter 2 Hardware changes

HP t610 Series Specifications

General

Power Supply	65W external power adapter
Processor	AMD G-T56N APU with Radeon HD 6320 Graphics (1.65 GHz, 1 MB L2 cache)
Graphics	AMD Radeon HD 6320 Graphics
Memory	4 GB DDR3 SDRAM
Storage	500 GB HDD
Networking	Gigabit Ethernet
USB Ports	6 x USB 2.0 (2 front, 4 rear)
Operating System	HP ThinPro, Windows Embedded Standard 7
Chipset	AMD A55E
Ports	1 serial, 1 parallel