HP t610 Series User Manual

Installing the rubber feet
CAUTION: To prevent loss of performance or damage to the thin client, be sure to install the rubber
feet before operating the thin client in a horizontal orientation.
To install the rubber feet:
1. As you face the front of the thin client, lay the thin client on its left side.
2. Remove the feet from their backing.
3. Press each foot down securely onto a corner of the right side of the thin client.
Figure 1-4 Installing the rubber feet
Installing the rubber feet 5

HP t610 Series Specifications

General

Power Supply	65W external power adapter
Processor	AMD G-T56N APU with Radeon HD 6320 Graphics (1.65 GHz, 1 MB L2 cache)
Graphics	AMD Radeon HD 6320 Graphics
Memory	4 GB DDR3 SDRAM
Storage	500 GB HDD
Networking	Gigabit Ethernet
USB Ports	6 x USB 2.0 (2 front, 4 rear)
Operating System	HP ThinPro, Windows Embedded Standard 7
Chipset	AMD A55E
Ports	1 serial, 1 parallel