2. Align the tabs on both sides of the cover and press the front edge down firmly until the latch
closes.
Figure 2-4 Replacing the metal side cover
Replacing the side access panel
To replace the access panel:
1. Place the access panel on the side of the unit, offset about 6.35 mm (1/4 inch) toward the top of
the unit (1), allowing the hooks on the underside of the panel to slip into notches in the side
access panel.
2. Slide the panel toward the bottom of the unit until it locks into place (2).
Figure 2-5 Replacing the side access panel
Removing and replacing the side access panel and metal side cover 13
To Next Page
Loading...
