Setting up the software
Windows XP initial setup
This section describes how to install the docking station software on a computer running the Windows®
XP operating system.
1. With the computer on and Windows running, connect the USB cable from the docking station to
the computer. The Choose Setup Language dialog box opens.
2. To select a language different from the language of the operating system, choose a language from
the list, and then click OK.
3. To install the requirements, click Install.
4. To install the DisplayLink driver, choose a language, and then click I Accept.
5. To install the other drivers, click Next, and then click Install.
6. To complete the installation process, click Finish. The USB docking station icon is added to the
notification area, at the far right of the taskbar.
Windows Vista initial setup
This section describes how to install the docking station software on a computer running the Windows
Vista® operating system.
1. With the computer on and Windows running, connect the USB cable from the docking station to
the computer. The AutoPlay dialog box opens.
2. Select Always do this for software and games checkbox, and then click Run loaderw.exe.
3. In the User Account Control dialog box, click Allow.
4. To select a language different from the language of the operating system, choose a language from
the list, and then click OK.
5. To install the requirements, click Install.
6. In the User Account Control dialog box, click Allow.
7. To install the DisplayLink driver, choose a language, and then click I Accept.
8. To install the other drivers, click Next, and then click Install.
9. To complete the installation process, click Finish. The USB docking station icon is added to the
notification area, at the far right of the taskbar.
After initial software installation, whenever you connect the docking station to the computer while
Windows is running, the User Account Control dialog box opens.
6 Chapter 1 Getting started
To Next Page
Loading...
