2 How to Install Accessories In Your PC
Installing Mass Storage Devices
24 English
2
Installing Accessories
5 Connect the data and power cables to the rear of the device installed
in the middle shelf. The connectors are shaped to go in one way
only. If you are not sure which connector to use, refer to
“Connecting IDE Devices”, on page 21.
6 Install any other accessories before replacing the cover. Reconnect
all cables and power cords.
7 Verify the new configuration by checking the HP Summary Screen.
Refer to the “The HP Summary Screen”, on page 42.
WARNING Do not open the CD-ROM drive enclosure as there is a danger of
electric shock, and the laser beam light could harm your eyes. Service
should be carried out by qualified personnel. This PC is a class 1 laser
product.
Installing an IDE Hard Disk Drive in the Rear Shelf
Refer to the drive’s manuals to see if you must set jumpers or if there is
a special installation procedure to follow.
1 Disconnect the computer’s power supply cord and any connection to
a telecommunications network.
2 Remove the computer’s cover.
Power cable
Data cable
To Next Page
Loading...
