3 The HP Setup Program
Using the Setup Program
44 English
3
HP Setup Program
Using the Setup Program
1 Turn on the display and then the PC. If the PC is already turned on,
save your data and exit all programs, then restart the PC. Consult
your operating system documentation for any special instructions
concerning turning off and then restarting your PC.
2 Press while
F2=Setup is displayed at the bottom of the screen.
F2=Setup appears for a short period, during the POST (Power-On-
Self-Test). If you fail to press in time and the start-up process
continues, you will need to restart your PC to go through the POST
again so you can press .
3 A display of the PC’s Setup program will appear, similar to the one
below. Note that “Main” is initially highlighted.
NOTE In addition to the Exit menu, you can also use the key to save your
settings and exit the Setup program.
PhoenixBIOS Setup — Copyright 1985-96 Phoenix Technologies Ltd.
Copyright 1996 Hewlett-Packard Rev. GX.07.xx
Main Configuration Security Power Exit
Item-Specific Help
Running Windows 95 [No] If you are not running Windows
95, the BIOS setup program
will offer you some of the
Windows 95 features and
optimize the use of hardware
resources.
System Time [13:06:48]
[11/16/1996]System Date
Key click [On]
Key auto-repeat speed
[21.8 per Second]
Delay before auto-repeat [0.5 Second]
Numlock at POWER-ON [On]
F1 Help
á
â
Select Item F7/F8 Change Values F9 Setup Defaults
ESC Exit
ßà
Select Menu Enter Select > Sub-Menu F10 Previous Values
To Next Page
Loading...
