3 The HP Setup Program
The HP Summary Screen
42 English
3
HP Setup Program
The HP Summary Screen
HP Summary Screen
Check your PC’s configuration when you first use the PC and each time
after you install, remove, or upgrade accessories. To check the
configuration:
1 Turn on the display and then the PC. If the PC is already turned on,
save your data and exit all programs, then restart the PC. Consult
your operating system documentation for any special instructions
concerning turning off and then restarting your PC.
2 While the Vectra logo appears on your display, press . This will
take you to the HP Summary Screen. (To go immediately into the
Setup program, and bypass the Summary Screen, press instead
of ). The Summary Screen will appear for only a short time. To
retain the screen indefinitely (until you decide to leave it), press
.
To Next Page
Loading...
