2 How to Install Accessories In Your PC
Installing Mass Storage Devices
26 English
2
Installing Accessories
Installing an IDE Hard Disk Drive in the Bottom Shelf
Refer to the drive’s manual to see if you must set jumpers or if there is
a special installation procedure to follow.
1 Disconnect the computer’s power supply cord from the power outlet,
and disconnect the PC from any telecommunications network.
2 Remove the computer’s cover.
3 Remove the CD-ROM drive (if present) from the middle shelf or
remove the middle bezel.
4 Remove the two bezels from the bottom shelf. The bezels snap in and
out, and can be removed without any tools.
5 Support the power supply with your hand (to prevent it falling out)
and carefully turn the PC onto its side.
To Next Page
Loading...
