English 29
2 How to Install Accessories In Your PC
Installing Mass Storage Devices
2
Installing Accessories
4 Remove the two bezels from the bottom shelf. The bezels snap in and
out, and can be removed without any tools.
5 Slide the drive completely into the bottom shelf and secure it with
the screws provided with the device. Replace the side bezel.
6 Connect the data and power cables to the rear of the drive and to the
PC (refer to the instructions that come with the tape drive).
7 Replace the CD-ROM (if present) in the middle shelf.
8 Install any other accessories before replacing the cover. Reconnect
all cables and power cords.
9 Verify the new configuration by checking the HP Summary Screen.
Refer to the “The HP Summary Screen”, on page 42.
To Next Page
Loading...
