English 37
3 Replacing Hardware Components
Replacing the Hard Disk Drive
4 Loosen the tray’s four screws and remove the old hard drive.
5 Align the new hard drive in the tray (with the correct orientation)
and tighten the screws.
6 Slide the drive tray back into the bay and close the lever.
7 Attach the data and power connectors.
CAUTION Ensure that you route the hard drive power cable correctly. Do not
pinch the cable when closing the hard drive tray’s lever.
8 Replace the cover (described in this chapter).
gap.bk : gap-3.fb4 Page 37 Friday, January 15, 1999 5:03 PM
To Next Page
Loading...
