To Next Page

To Previous Page

Removing the Monitor Stand

You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other

mounting fixture.

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the

power and signal cables are both disconnected. Also disconnect all USB cables connected to the

monitor.

1. Disconnect and remove the signal, power, and USB cables from the monitor.

2. Lay the monitor face down on a flat surface covered by a clean, dry cloth.

3. Pivot the stand 45 degrees clockwise and remove the lower right mounting screw from the back

of the monitor, then pivot the stand 45 degrees counter-clockwise and remove the lower left

mounting screw from the back of the monitor.

4. Remove the two upper mounting screws (1) then lift the stand off the monitor (2).

Removing the Monitor Stand 15

Questions and Answers:

Need help?

Do you have a question about the HP Z22i and is the answer not in the manual?

HP Z22i Specifications

General